User`s guide

Small Office Remote Access Switch 489
R EMOTE M ANAGEMENT
Remote Installation with USER2
REMOTE INSTALLATION WITH USER2
The CyberSWITCH is delivered with a default configuration. This default configuration includes a
configured device, USER2. Advanced users may use the default configuration to perform the
configuration of a remote CyberSWITCH. The network must be setup as illustrated below to take
advantage of remote configuration through USER2.
To begin, you must have an ISDN device with a WAN and LAN connection (we recommend an
CyberSWITCH), a simple two node LAN, and a computer with a TCP/IP stack with a Telnet client
which you can reconfigure.
After you have your setup complete, you must:
1. Minimally configure the remote CyberSWITCH:
a. switch type (US only)
b. point-to-point or point-multi-point line
c. SPIDS for DMS-100 and NI-1 lines
2. Configure your local ISDN device using the following information:
Name:USER2
Secret:USER2
Security:CHAP only
WAN IP:2.2.2.3
LAN IP:an unused IP address on your local LAN
Static Route:to 1.1.1.1 (mask 8), next hop 2.2.2.2
single user:
Name:LINK
Secret:LINK
Device Type:PPP
IP Address:2.2.2.2
TCP / IP
Client
User 2
User with
default configuration
ISDN
CSX150
CSX150