User`s guide

Small Office Remote Access Switch 325
C ONFIGURING O THER A DVANCED O PTIONS
Log Options
DATA RATE
This field indicates the data rate for a B channel. The possible values are 56 Kb, 64 Kb and 384 Kb.
D
URATION
This field reflects the time that a connection is active; it is presented in hours, minutes and seconds.
The precise meaning varies somewhat for a successful connection versus a call rejection.
E
VENT TYPE
This field indicates what type of event the associated message is reporting. The possible values are
‘CONNECT’, ‘DISCONNECT’, ‘REJECT’, ‘SYSTEM UP’ and ‘CDR VERIFY’.
NAS N
AME
NAS Name (Network Access Server Name) contains the System Name of the system logging the
message.
P
HONE NUMBER
On incoming calls this field contains the Calling Line Id of the caller if the information is available
(some switches do not provide Calling Line Id). On outgoing calls, this field contains the phone
number of the remote device that the system is calling.
R
EMOTE DEVICE NAME
This field contains the name of the remote device, if available.
S
LOT, LINE AND BEARER
This field identifies the slot (or resource), the line and the bearer channel used for the associated
connection.
T
IME STAMP
The field contains the time and date. The meaning of this field varies depending upon the report.
Connect Event Report Contents
On a connect event, records 1 through 3 are used. The event type is CONNECT. The timestamp
reflects the time that the ISDN connect message was received from the switch. An incoming phone
number is displayed if it is provided by the telephone switch. Not all switches provide calling line
identification. A phone number is always displayed for outbound calls.
The following are example connect event reports:
example 1:
Chicago-Schaumburg 00000001 CONNECT 1 OF 3 MonroeCounty PORT 1/1/1
Chicago-Schaumburg 00000001 CONNECT 2 OF 3 IN FROM 3135551212
Chicago-Schaumburg 00000001 CONNECT 3 OF 3 64Kb 08/16/95 23:11:55
example 2:
Chicago-Schaumburg 00000001 CONNECT 1 OF 3 MonroeCounty PORT 1/1/1
Chicago-Schaumburg 00000001 CONNECT 2 OF 3 OUT TO 3135551212
Chicago-Schaumburg 00000001 CONNECT 3 OF 3 64Kb 08/16/95 23:11:55
Note: In most cases, a device is identified when a connect event occurs and the device name is
included in the connect report. With user level security, the connect event occurs before the
user is identified. Therefore, the connect report will contain a name of UNKNOWN. The
disconnect report will have the actual user name, as determined by SENTRY. The
connection Id from the connect and disconnect reports will match.