User`s guide

USER’S GUIDE
154 CyberSWITCH
The following table identifies the configuration requirements for possible security options for PPP
IP Devices.
*Required: An IP address is required if the remote device does not support IP address negotiation.
When the remote device does support IP address negotiation, an IP address is not required.
Note: If CHAP Security is enabled, and Outbound Authentication has not been disabled, a CHAP
Secret must be entered for both the remote device and for the CyberSWITCH. Refer to
System Information for information regarding the System Secret. If Outbound
Authentication has been disabled, a CHAP Secret is not required for the remote device.
Bridging with PPP Bridge Devices (Using BCP)
To allow a PPP Bridge device to connect to the CyberSWITCH, you must have Bridging enabled.
For each PPP Bridge device using this type of connection, you may need to enter a PAP Password
or a CHAP Secret, and a Calling Line Id.
The following table identifies the configuration requirements for possible security options for PPP
Bridge Devices.
Note: If CHAP Security is enabled, and Outbound Authentication has not been disabled, a CHAP
Secret must be entered for both the remote device and for the CyberSWITCH. Refer to the
System Information for information regarding the System Secret. If Outbound
Authentication has been disabled, a CHAP Secret is not required for the remote device.
Security Mode Configuration On-node Device Table Configuration Data
Calling Line Id PAP or CHAP
Security
Calling Line Id PAP Password
or
CHAP Secret
IP Address
Disabled Enabled Not Requested Required *Required
Enabled Enabled Optional per
device entry
Optional *Required
Enabled Disabled Required Optional Optional
Security Mode Configuration On-node Device Table Configuration
Data
Calling Line Id PAP or CHAP
Security
Calling Line Id PAP Password or
CHAP Secret
Disabled Enabled Not Requested Required
Enabled Enabled Optional per
device entry
Required
Enabled Disabled Required Optional