User`s guide

Small Office Remote Access Switch 153
C ONFIGURING D EVICE L EVEL D ATABASES
On-node Device Entries
The following table identifies the configuration requirements for possible security options for IP
Routing with Bridge Devices.
*Conditionally Required means you must specify at least one of either the Calling Line Id or the
Ethernet Address. You may specify both.
IP Routing with IP Host Devices (RFC1294)
To allow an IP Host device to connect to the CyberSWITCH, you must have IP Routing and IP Host
Security enabled. For each IP Host device using this type of connection, you may need to enter the
device’s IP address, IP Host Id, and Calling Line Id.
The following table identifies the configuration requirements for possible security options for IP
Host devices.
IP Routing with PPP IP Devices (Using IPCP)
To allow a PPP IP device to connect to the CyberSWITCH, you must have IP routing enabled. For
each PPP IP Device using this type of connection, you may need to enter the device’s IP address, a
PAP Password or a CHAP Secret, and Calling Line Id.
Security Mode
Configuration
On-node Device Table Configuration Data
Calling
Line Id
Bridge
Ethernet
Address
Calling Line Id Bridge
Ethernet
Address
Bridge Password IP (Sub) Network
Number
Enabled Disabled Required Not
Requested
Not Requested Required if only IP
Routing is Enabled
Disabled Enabled Not
Requested
Required Optional per
device entry
Required if only IP
Routing is Enabled
Enabled Enabled Conditionally
Required*
Conditionally
Required*
Optional per
device entry
(if entry
specifies an
Ethernet
Address)
Required if only IP
Routing is Enabled
Security Mode Configuration On-node Device Table Configuration Data
Calling Line Id IP Host Id Calling Line Id IP Host Id IP Address
Disabled Enabled Not Requested Required Required
Enabled Enabled Optional per
device entry
Required Required