User`s guide

USER’S GUIDE
152 CyberSWITCH
ON-NODE DEVICE DATABASE SECURITY REQUIREMENTS
The following sections provide the On-node Device Table configuration requirements for possible
security option configurations for each category of remote device. Categories are defined by the
operating mode (bridging or routing), and the line protocol in use.
Bridging with HDLC Bridge Devices
To allow a Bridge device to connect to the CyberSWITCH, you must have MAC Layer Bridging
enabled. For each HDLC bridge device using this type of connection, you may need to enter the
Device Name, Calling Line Id, Remote Bridge Ethernet Address, and Password.
The following table identifies the configuration requirements for possible security options for
remote bridge devices.
*Conditionally Required means you must specify at least one of either the Calling Line Id or the
Ethernet Address. You may specify both.
IP Routing with HDLC Bridge Devices
To allow devices to connect to the CyberSWITCH using IP routing through a Bridge device, you
must configure a RLAN Interface. IP routing must also be enabled. For each HDLC Bridge using
this type of connection, you may need to enter the Device Name, Calling Line Id, Remote Bridge
Ethernet Address, Bridge Password, and IP (Sub) Network Number.
Security Mode Configuration On-node Device Table Configuration Data
Calling Line Id Bridge Ethernet
Address
Calling Line Id Bridge Ethernet
Address
Bridge Password
Enabled Disabled Required Not
Requested
Not Requested
Disabled Enabled Not Requested Required Optional per
device entry
Enabled Enabled Conditionally
Required*
Conditionally
Required*
Optional per
device entry
(if entry specifies
an Ethernet
Address)