User`s guide

Small Office Remote Access Switch 143
C ONFIGURING D EVICE L EVEL D ATABASES
On-node Device Entries
For IP Remote LAN networks, you must explicitly configure the IP (Sub)Network number.
For IPX Remote LAN networks, you may configure the IPX external network number, or you
may leave the value at NONE. The IPX Spoofing Options for IPX Remote LAN devices are not
available at this time. For additional information, please refer to the Configuring IPX chapter,
Remote LAN Devices.
For AppleTalk Remote LAN networks, you may configure the AppleTalk network number/
range (used on the Remote LAN for this device), or you may leave the value at NONE.
13. To enter any needed POTS information for your device, select POTS Priority Information from
the Device Table Configuration Menu. The following screen will be displayed:
Select the type of POTS priority you want for this device.
14. To enable per-device compression information, select Compression from the Device Table
Menu. The following menu will then be displayed:
a. If compression is not already enabled for this device, press 1 and follow the onscreen
instructions to change the configuration to enabled.
b. If the remote device does not use 1 as the starting PPP STAC-LZS sequence number, press
2 to enter a new value for the starting sequence number.
U
SING MANAGE MODE COMMANDS
device
Displays the current Device Table. Included in this display is each device’s ID and name. After
the list has been displayed, you may enter a specific device Id to display detailed information
for that device.
device add
Allows you to add a device entry to the Device Table. You will be prompted for the device
name and device type. The rest of the information you will be prompted for will depend upon
the device type you are configuring, and the security options that are enabled. Note that the
device name is case sensitive. You are prompted for the device information similarly to the way
you are prompted by CFGEDIT. Refer to the above section, Using CFGEDIT for instructions.
Change POTS Priority Information (Device = "USER1")
1) Preemption Of 2nd B-channel by POTS
2) Disconnection by POTS for last B-channel
Select function from above or <RET> for previous menu:
Device Compression Menu: (device = "DAN")
1) Compression ENABLED
2) Starting PPP STAC-LZS Sequence Number 1
Select function from above or <RET> for previous menu: