Specifications

Software Superseded by CS2/MMS2 Software Release Notice for 5.0rev1
5-18 CS2 and MMS2
The Chassis view for SS6000 devices has an area on the right side of the view
for chassis power supply and fan information. Currently no information shows
in these boxes. The appropriate methods need to be updated to include
appropriate instance information during the reads.
The view of the SmartSwitch 6000 backplane does not show the backplane
ports (b1, b2, b3, b4, b5) correctly. The ports are not shown in numerical order;
at times they show up in random order. The problem is an array indexing
problem. A new default type was created, and all interfaces read from the OID
table are automatically added to the list, effectively putting the HostPort
interface at the end of the list. This takes care of the array indexing issue for
the SS6000 devices.
After moving a card in the 9000 chassis to another chassis the new inb and
chassis are not being created.
When a 9000 (MMACPlus) board is removed from the chassis and then
reinserted, its System Up Time is reset to zero. Spectrum detects this and
attempts to reconfigure. If the board was moved from one slot in a chassis to a
different slot in the same chassis, this is correctly identified, and the DevTop
and Chassis Device views etc. are repainted with the board in the new slot
location.
However, if a board is moved from one chassis to a different chassis, Spectrum
is not detecting this. If a board is moved from slot 5 in chassis 1 to slot 10 in
chassis 2, Spectrum incorrectly thinks the board is now in slot 10 (good) of
chassis 1. It doesn't create a model for chassis 2, or the INB of chassis 2, etc.
(Also refer to the Notes on corrected anomalies, on Page 5-12.)
SPECTRUM_5.0rev1.P50
The 3Com SuperStack II FMS Token Ring Hub has extra ports supported in
its MIB called the Router, RingIn, RingOut and Cascade ports. These are in a
different table from the standard ports. Support is required for these extra
ports so that they can be displayed properly in the Device and DevTop Chassis
Views. The resolution was to add the GIB files and database changes that
were required.
AutoDiscovery is not fully supported in the current module. The 3Com FMS
Token Ring Hub has extra ports in addition to its normal repeater ports.
There are 4 types of ports of which there can normally be up to one of each on
a stackable hub unit. These are the Router, RingIn, RingOut and Cascade
ports. Currently the Router port is the only one which can contain MAC
Address information. This port is currently unsupported in AutoDiscovery.
The resolution was to create the necessary inference handler to support the
Router port.
When AutoDiscovery runs on the 3Com SuperStack II from the Universe view
a Hub3ComSSTR_A is properly created. There are a few evident problems
that occur.