Specifications

MMS2 Software Characteristics Software Release Notice for 5.0rev1
4-4 CS2 and MMS2
27. AutoDiscovery no longer hangs if the address range includes Wellfleet
BLN II routers.
28. Alarms are now supported for the Cisco Access Server, AS5x00.
29. The SmartSwitch Router physical and Logical Device views have been
modified so that Quad Serial and Dual HSSI modules now show correctly.
30. The DevTop view now launches correctly for the Cabletron 9A686-04
model type.
31. Double-click zones for the Hub3ComLS3000 Topology view icon and Off
Page Reference icon now both access the same DevTop view.
32. A yellow, clearable alarm is now generated when a Cabletron
SmartSwitch 9000 device is not associated with a chassis.
33. Default icons are no longer created in the DevTop views of SM-3CM1008.
34. RMONEthProbe no longer fails as monitor point on the Cabletron 6E233-
49 device.
35. The HSIM-W6 is no longer created as a CSX400/200 when modeled by IP.
MMS2 Known Anomalies
Following are the known anomalies in MMS2, listed as they apply (i.e., by
device type, management module number, application, or model type).
HSIM-W6 High Speed Interface Module
The Device Topology view does not display. An error message is generated.
The Device Interface view does not display any interfaces.
The Model Information view displays ??? for Model State, Condition, and
Contact Status.
SM-CSI1012
FDMMIM
For the FDDI and Ethernet ports, the Port Configuration view generates
the error message: Model to read from is Null.
SM-CSI1014
Standard RMON App
The performance information is red boxed in the Token Ring Promiscuous
Segment Performance view.