Specifications

Installation Software Release Notice for 5.0rev1
2-4 CS2 and MMS2
CS2 Post-Installation Instructions
Once you have completed the CS2 installation, perform the following steps to
verify and modify your files as necessary.
1. Change directory to <SPECTRUM Home>/app-defaults and compare
the file CsStdMenu with CsStdMenu.ori, the file you saved prior to this
installation. Edit CsStdMenu to restore any customized settings you may
have had in CsStdMenu.ori.
2. Change directory to <SPECTRUM Home>/SG-Tools and compare the
file dtxscript with dtxscript.ori, the file you saved prior to this
installation. Edit dtxscript to restore any customized settings you may
have had in dtxscript.ori.
3. If there is no need to install MMS2 (see Note below), bring up the Control
Panel and start the SpectroSERVER and/or SpectroGRAPH; otherwise,
proceed with the installation of MMS2.
Installing MMS2
You must install the management modules included as part of MMS2 that are
currently installed in your SPECTRUM 5.0rev1 database. Also, you should
install any additional management modules that you have purchased. (See
Management Modules Included in MMS2, starting on Page 4-8.)
The procedure for installing management modules from the MMS2 portion of
the CD is the same as the one for installing management modules described in
the SPECTRUM Installation Guide, which is available on Cabletron’s Web
site at http://www.cabletron.com/support/manuals/.
NOTE
You need not install any portion of MMS2 if (and only if) your SPECTRUM
5.0rev1 database does not contain a management module included in MMS2.
This will NOT be the case for most installations. See Management Modules
Included in MMS2, starting on Page 4-8.