User`s guide

WAN Configuration Using Local Management
CSX200 Family User’s Guide 167
b. If you selected FR, use the arrow keys to highlight FR LMP. Press the SPACEBAR to select
T1.617-D, Q.933-A, or NO LMI, then press ENTER.
• Use the arrow keys to highlight DLCI Address. This field can be set to values from
0–1023. The values 16–991 are typically used for virtual circuits.
• Use the arrow keys to highlight CKT_DCP Enable. Press the SPACEBAR to select
ON, if you want data compression enabled or OFF, if you do not, then press ENTER.
• If you selected NO LMI, Use the arrow keys to highlight Circuit State. Press the
SPACEBAR to select Active, then press ENTER.
4. Use the arrow keys to highlight the SAVE command. Press ENTER. The message “SAVE
DONE!” displays and Local Management saves the changes to memory. The interface is
assigned to an application port (PT#) in the table.
The WAN configuration is complete. It takes up to 60 seconds for the WAN Interface to come out
of standby and for communications to begin.