Manualshelf

User`s guide

ManualsBrandsCabletron Systems ManualsComputer equipmentCyberSWITCH CSX202
171172173174175176177178179180
WAN Configuration Using Local Management
166 CSX200 Family User’s Guide
DDS Physical Configuration
The WAN Physical Configuration screen is accessed from Local Management by using the arrow
keys to highlight the WAN SETUP option on Setup Menu screen (see Chapter 6), and pressing
ENTER. The WAN Physical Configuration screen shown in Figure 75 displays.
1. Use the arrow keys to highlight DDS Line Mode. Press the SPACEBAR to set the DDS Line
Mode to DDS-PRI or DDS-CC, then press ENTER.
2. Use the arrow keys to highlight DDS Tx Clock Source. Press the SPACEBAR to set to Loop,
then press ENTER.
3. Use the arrow keys to highlight DDS Loopback. Press the SPACEBAR to set to NONE, then
press ENTER.
4. Use the arrow keys to highlight the SAVE command. Then press ENTER. The message “SAVE
DONE!” displays and Local Management saves the changes to memory.
Access the WAN Interface Configuration screen (Figure 76) by using the arrow keys to highlight
the WAN INT CONFIG option, then press ENTER.
DDS Interface Configuration
This screen is accessed through the WAN Physical Configuration screen. Refer to Figure 76 and
proceed with the following steps to configure the WAN Interface through Local Management.
1. Use the arrow keys to highlight Interface Number. Set the WAN connection Interface Number
by typing the same number found in the Interfaces field on the WAN Physical Configuration
screen into the Interface Number field, then press ENTER. In this example, the Physical
Configuration screen shown in Figure 75 uses Interface 002 for the WAN connection.
2. Use the arrow keys to highlight Line Coding. Press the SPACEBAR to select NONE, then
press ENTER.
3. Use the arrow keys to highlight Active Protocol. Press the SPACEBAR to select PPP or FR,
then press ENTER.
a. If you selected PPP, complete the following:
• Use the arrow keys to highlight PPP Type. Press the SPACEBAR to select BNCP, then
press ENTER.
• Use the arrow keys to highlight CCP Enable. Press the SPACEBAR to select ON, if
you want data compression enabled or OFF, if you do not, then press ENTER. Go to
step 4.