User`s guide

WAN Configuration Using Local Management
160 CSX200 Family User’s Guide
DDS Physical Configuration
To configure the WPIM-DDS for the CSX203 or CSX200, access the WAN Physical
Configuration screen for the WPIM-DDS, shown in Figure 75, by using the arrow keys to
highlight the WAN SETUP menu item on Setup Menu screen (refer to Chapter 6) and pressing
ENTER. The WAN Physical Configuration screen displays.
Figure 75 WAN Physical Configuration Screen
WAN Physical Configuration Screen Fields
The following sections describe WAN Physical Configuration screen fields and instructions for
setting them. The WAN Physical Configuration screen lets you configure the Physical Interface.
The WAN Physical Configuration screen displays the following information.
WPIM 1 — Displays configuration information for as many as four WPIMs.
Type — Displays the WPIM type.
BRIM # — Displays the BRIM slot in which the WPIM resides.
SAVE WAN INT CONFIG RETURN
Type: DDS
BRIM #: 1
Mode: [Primary]
Active: Yes
Ifaces: 002
WAN PHYSICAL CONFIGURATION
DDS Line Mode:
DDS Tx Clock Source:
DDS Loopback:
WPIM 1 Line Configuration
148202
CSX200 Local Management Flash Image Version: xx.xx.xx
[WPIM 1]
WPIM 1
[DDS-PRI]
[Loop-Timing]
[NONE]
DDS In-Speed:
DDS Out-Speed:
[56000]
[56000]