User`s guide

WAN Configuration Using Local Management
CSX200 Family User’s Guide 151
The WAN configuration is complete. Communication between the CSX200 and the service
provider’s switch takes approximately 1 to 2 minutes to begin. A status of Inactive displays until
both ends of the PVC (Permanent Virtual Circuit) are configured. Once both end devices have
negotiated link management with the switches, the status field reads Active.
Synchronous Physical Configuration
To configure the WPIM-SY for the CSX203 or CSX200, access the WAN Physical Configuration
screen for the WPIM-SY, shown in Figure 71, by using the arrow keys to highlight the WAN
SETUP menu item on Setup Menu screen (refer to Chapter 6), and pressing ENTER. The WAN
Physical Configuration screen displays.
Figure 71 WAN Physical Configuration Screen
NOTE
Upon saving this screen, the interface just configured is assigned to an application
port (PT#) in the table on the right hand side of the screen once the device starts
communicating with the service provider’s switch.
SAVE WAN INT CONFIG RETURN
Type: SY
BRIM #: 1
Mode: [Primary]
Active: Yes
Interfaces: 002
WAN PHYSICAL CONFIGURATION
Sync Port Type: [V.35]
Force CTS True: [No]
Force DSR True: [No]
WPIM 1 Line Configuration
CSX200 Local Management Flash Image Version: xx.xx.xx
[WPIM 1]
WPIM 1
Sync Clock Source: [External]
Sync Tx Clock Speed: 64000
Sync Rx Clock Speed: 64000
WPIM 1 Clock Configuration