User`s guide

WAN Configuration Using Local Management
136 CSX200 Family User’s Guide
T1 Physical Configuration
To configure the WPIM-T1 for the CSX200, access the WAN Physical Configuration screen for
the WPIM-T1, shown in Figure 64, by using the arrow keys to highlight the WAN SETUP menu
item on Setup Menu screen (refer to Chapter 6), and pressing ENTER. The WAN Physical
Configuration screen displays.
Figure 64 WAN Physical Configuration Screen
WAN Physical Configuration Screen Fields
The following sections describe WAN Physical Configuration screen fields and instructions for
setting them. The WAN Physical Configuration screen lets you configure the “Physical Interface.”
The WAN Physical Configuration screen displays the following information:
WPIM 1 — Displays configuration information for the WAN port.
Type — Displays the port type (T1).
BRIM # — Displays the slot in which the T1 port resides (in this case the slot is always “1”).
SAVE WAN INT CONFIG RETURN
Type: T1
BRIM #: 1
Mode: [Primary]
Active: Yes
Interfaces: 002-025
WAN PHYSICAL CONFIGURATION
T1 Timeslot View:
T1 Line Coding:
T1 Frame Type:
T1 Tx Clock Source:
T1 Line Buildout:
T1 Network Loopback:
WPIM 1 Timeslot Configuration
000 000 000 000 000000 000 000
01-08
09-16
17-24
WPIM 1 Line Configuration
000 000 000 000 000000 000 000
000 000 000 000 000000 000 000
148201
CSX200 Local Management Flash Image Version: xx.xx.xx
[WPIM 1]
WPIM 1
[Active]
[B8ZS]
[ESF]
[Loop-Timing]
[0 db]
[None]