User`s guide

General Configuration Using Local Management
114 CSX200 Family User’s Guide
Bridge Setup Screen Fields
The following list describes each of the Bridge Setup screen fields:
Spanning Tree Protocol — Use this field to select a Spanning Tree protocol. Possible selections
for this field are IEEE 802.1, DEC, or NONE.
Bridge Port Admin Status — Use this field to enable or disable individual CSX200 bridge ports.
Possible selections for this field are ENABLED or DISABLED.
Bridge Port Pair Admin Status — Use this field to enable or disable bridging between bridge
port pairs. For example, you can enable Port 1 to bridge traffic to all ports except Port 2.
Bridge_Port X — Use this command field to select the CSX200 bridge port you want to
configure.
Selecting a Spanning Tree Protocol
To select the Spanning Tree protocol to be used by the CSX200, perform the following steps:
1. Use the arrow keys to highlight the SPANNING TREE PROTOCOL field.
2. Press the SPACEBAR or BACKSPACE to select [IEEE 802.1], [DEC], or [NONE].
3. Use the arrow keys to highlight the SAVE command field.
4. Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.
Selecting the Bridge Port Administrative Status
To select the bridge port administrative status, perform the following steps:
1. Use the arrow keys to highlight the [BRIDGE_PORT XX] field at the bottom of the Bridge
Setup screen.
2. Press the SPACEBAR or BACKSPACE to select the bridge port you want to configure. The
selected bridge port displays in the Bridge Port Admin Status field.
3. Use the arrow keys to highlight the BRIDGE PORT ADMIN STATUS: PORT X - - > ALL
PORTS [ENABLED] field.