User`s guide

USER’S GUIDE
92 SFVRA Configuration Manager
MODIFYING CONNECTION INFORMATION
For each connection configured, there is default information that was extracted from the site
template associated with the system’s site, and also from previously configured circuit information
(e.g., Authentication, Restriction, Access, and Protocol information). Changes should not be
necessary for most of this information, with the following exceptions.
• You may need to adjust dial-out numbers (e.g., you may need to add a prefix to the number).
• If the connection uses CLID security, you will need to enter Calling Line IDs.
• If you are using the Bandwidth Reservation feature for this connection group, you will need to
select the appropriate circuit group.
• If IP is enabled on the connection, an IP Subnet must be selected.
• If AppleTalk is enabled on the connection, an AppleTalk segment must be selected.
ADJUSTING TELEPHONE NUMBERS
To adjust connection telephone numbers:
1. From the Connection Groups’ main dialog box, click on the Connection Group Name that is
associated with the telephone number you want to change, then click on Select (or simply
double click on the Connection Group Name).
2. From the resulting screen, click on Edit Group Connections.
3. From the resulting [Site Name] Connections screen, click on the particular connection that you
want to make the changes to, then click Edit (or simply double click on the connection). In the
screen shown below, we are selecting the connection between Macon County and Macon
Elementary.