User`s guide

C ONFIGURING S ITES
OVERVIEW
After you have designed site templates (refer to Configuring Site Templates), you can then define
individual sites. For each site you will enter various site properties (including the site template you
wish to use for this site), optional contact information, and the systems associated with this site.
ADDING A SITE
The initial steps to configuring a site are as follows:
1. From the menu bar, click on Functions then click on Sites, or click on the toolbar.
2. Click on Add.
3. You can now configure site properties, contacts, and systems.
CONFIGURING SITE PROPERTIES
1. Enter a user-defined Site Name (maximum of 17 characters).
2. Select a User Database for user authentication. Choices are:
• Local User Table
• SFVRA
• Other (for systems not configured by the SFVRA-CFG)
3. If you selected a Local User Table or SFVRA database, select a Site Template from the list of
previously configured templates.
4. If you selected an SFVRA database, select a Database Site from the previously configured list.
Refer to Configuring the SFVRA Database Table for instructions on configuring SFVRA database
information.
5. Enter the Device Authentication information.
a. Enter the site’s device authentication Name. Note that multiple sites can use the same
authentication name.
b. If your site uses PAP security, enter the User Password.
c. If your site uses CHAP security, enter the CHAP Secret.
6. If applicable, enter the site’s ISDN Subaddress. A subaddress may be configured for a point-
multipoint line.
7. If you are adding a site to a network that is already completely configured (i.e., connection
groups have already been configured), you can select the site’s Connection Group from the list