User`s guide

USER’S GUIDE
50 SFVRA Configuration Manager
This parameter allows you to maintain compatibility with these devices by setting the MTU to
agree with that supported by the device.
4. Select a Host Routes Propagation scheme. This controls how the IP RIP packets are propagated.
If disabled, WAN local routes are propagated as subnetwork routes. If enabled, host routes will
be propagated on other network interfaces only while each remote IP device is connected to the
site.
Also, when enabled, it will allow multiple systems on the same LAN to work properly. IP RIP
information is then advertised as multiple host routes as they connect to the site.
5. Enter the RIP Configuration.
a. Send Control: Controls how IP RIP update messages are sent on an IP RIP interface. The
following table provides possible choices for IP RIP send control.
b. Receive Control: Controls which version of IP RIP updates are to be accepted. The following
table provides possible choices for IP RIP receive control.
c. Respond Control: Controls how the system responds to IP RIP requests on the interface. The
following table provides possible choices for IP RIP respond control.
Choice Meaning
Do Not Send This switch indicates sending no IP RIP packets
at all.
RIP Version 1 This switch indicates sending IP RIP updates
compliant with RFC 1058.
RIP Version 1
Compatibility
This switch indicates broadcasting IP RIP v2
updates using RFC 1058 route subsumption
rules.
RIP Version 2 This switch indicates multicasting IP RIP v2
updates compliant with RFC 1723.
Switch Meaning
Do Not Receive This switch indicates accepting no IP RIP updates
at all.
RIP Version 1 Only This switch indicates accepting only IP RIP
updates compliant with RFC 1058.
RIP Version 2 Only This switch indicates accepting only IP RIP v2
updates compliant with RFC 1723.
RIP Version 1 or
Version 2
This switch indicates accepting either IP RIP v1 or
IP RIP v2 updates.