User`s guide

USER’S GUIDE
116 SFVRA Configuration Manager
f. Enter the Transmit Broadcast Address. For a definition of transmit broadcast addresses, refer
to page 106.
4. Optional: configure Expert Options. Note, for most configurations, the default values will be
adequate. If you need to configure the expert options for this system, refer to the instructions
found under Configuring IP Network Subnet Interfaces (the instructions are identical for IP
network subnet and system configurations).
CONFIGURING IP NETWORK SYSTEM STATIC ROUTES
You only need to configure static routing entries for systems that need to access a WAN network
that is not directly connected to the system, or if the system needs to access a LAN network through
a router that does not support IP RIP. Static routes specify the IP address of the next hop router or
gateway that provides access to this subnet.
Remember that when configuring static routes through the IP system viewpoint, you are
configuring all the static routes that originate at this system.
To configure a system’s static routes:
1. Click on the Static Routes tab. The following screen will be displayed: