Specifications

Small Office Remote Access Switch 37

ONNECTIVITY

Connecting One Cabletron Product to another via PPP

c. Under Authentication you must:

• Change CHAP Secret so that it matches Remote’s System secret (Remote_S).

• Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).

d. Under IPX Information:

•enable IPX

•enable Make Calls for IPX data

•enable IPXWAN protocol

•select Triggered RIP/SAP with a WAN peer type of ACTIVE from the Routing Protocol

option

Note: By using triggered RIP/SAP, you do not need to configure static routes or services.

ONFIGURATION FOR SITE "REMOTE"

The configuration on Remote to allow IPX Routing to Central using PPP is as follows:

1. Perform initial configuration steps.

2. Under Options, select IPX Routing, then:

a. Enable IPX Routing.

b. Under IPX Internal Network Number enter the following value: 456789.

c. Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number

(33333333).

3. Under Security, select System Options and Information, then under System Information:

a. Set your System Name (Remote). This matches up with Remote device information

configured on Central.

b. Set your System Secret (Remote_S). This matches up with Remote device information

configured on Central.

4. Under Security, select Device Level Databases, select On-node Device Entries, then add a device

where the Device Name (Central) must match the system name on Central. When you add the

device you must then enter the following information:

a. Under ISDN Information select ISDN Line Protocol then select PPP.

b. Under ISDN Information you must enter a dial out number (13135551111) and a base data

rate (64Kb) to dial out to Central.