Specifications

9032277-04 Software Superseded by CS3/MMS3
5-15
Patches Issued After the CS1/MMS1 Release
SPECTRUM_5.0rev1.P40
While running SpectroSERVER, when SpectroWATCH executes a
script, a small memory leak occurs. This has been resolved by deleting
the memory appropriately.
While running SpectroSERVER, a small memory leak occurs in
SpectroWATCH. This has been resolved by deleting the memory
appropriately.
(Also refer to the Notes on corrected anomalies, above.)
SPECTRUM_5.0rev1.P41
Included in P48.
(Also refer to the Notes on corrected anomalies, on Page 5-14.)
SPECTRUM_5.0rev1.P42
Creating a model by IP via CLI, creates the device as Pingable. This
has been resolved by having it create a device with the correct model
type.
(Also refer to the Notes on corrected anomalies, on Page 5-14.)
SPECTRUM_5.0rev1.P43
After installing P23 the following message is printed out in the
VNM.OUT file: status=1 status=1, repeatedly. This was caused by
debug output left in the code. This has been removed.
RMONEthProbes are not being created after installing P23. This was
caused by code that was trying to filter out SMB10 interfaces. This has
been resolved by backing out the code to filter out the SMB10
interfaces.
When using the RMONEthProbe for the FEPIM Port on a 6E233-49
the Monitor Point watches will intermittently fail.
When you removed a probe as a monitor point it used to invalidate the
actual probe instances because the hex conversion was used, so it was
invalidating the wrong probe. The solution is to use the decimal
conversion.
The current RMON code was not searching free slots in
EtherStatsTable for more than 50 instances.This will cause a problem