Specifications

Problems Resolved in MMS3
Cabletron Management Module Problem Resolutions
MMS3 Software Characteristics Software Release Notice for 5.0rev1
4-6 CS3 and MMS3
SM-CSI1066, SmartSwitch 9000 (9H421_12)
The Port Bridging Status no longer displays UNK (unknown) in the
Device Chassis and Device Interface (Bridging mode) views.
SM-CSI1068/1080, SmartSwitch 2000 Ethernet and Fast
Ethernet
AutoDiscovery and Model by IP now detect duplicate models for all
model types. If a duplicate model is detected, an error message
appears and the model is not created a second time.
SM-CSI1068/1080/1087, SmartSwitch 2000 Ethernet, Fast
Ethernet, and Workgroup
Device Chassis views for all model types are now readable and the
ports are aligned correctly.
SM-CSI1073, SmartCell Switch
1. The DevTop view now launches appropriately.
2. There was a problem in which the DevTop view would be incorrect
when a SmartCell model was created and then a model was
created for a SmartSwitch 9000 module in the same chassis. The
DevTop view would be for the SmartSwitch 9000 module instead
of the SmartCell. The correct DevTop view now displays.
3. Devices that support distributed mode functionality now model
correctly. This includes the SFSmartCell and SmartSwitch 6000
DMF mode devices. They appear in the topology if created using
the Model by IP selection. There is no longer a message: Error:
Model Type of Device XXX.XXX.XXX.XXX already exists
and cannot be related to this viewed model.
Existing Model: 6C105 of Type 6C105.
4. Ports of the type ATMIfPort are now modeled in the DevTop view
of the 9A656_04 model.
SM-CSI1076, 6E132-25 (Ds3App1407)
1. The Model Information view and DS3/E3 Configuration view no
longer contain ??? in some of the information fields.
2. The Ds3App1407 name is now visible when the Application view is
in List mode.