Specifications

9032277-04 Installation

2-5

Installing CS3

Install the CS3 software as described below.

1. Change directory to <full path of the vtape_CS3 directory> to

verify the path (that is, {CD-ROM Drive directory}/CS3/

{platform}/vtape_CS3).

2. Change directory to the <SPECTRUM Home> directory.

3. Extract the contents of the release ﬁle labeled vtape.0 by

performing one of the following steps:

107709-02 SunOS 5.7: libssasnmp/libssagent/snmpdx/mibiisa

Patch

107716-02 SunOS 5.7: PGX32 Graphics Patch

Table 2-1. SunOS Patches for Solaris 2.7 (Minimum Revision Level)

Patch-rev Description

NOTES

1. Refer to the SPECTRUM Installation Guide for instructions on

installing from a local or remote CD-ROM drive.

2. For Windows NT, use the SpectroSHELL by selecting it from the

SPECTRUM Programs folder.

NOTE

There is a new version of "newtar" included with CS3 for extracting

the release contents for Solaris systems. The change to "newtar"

allows a -u ﬂag, which honors umask even if run as the root user.

This means that SPECTRUM can extract the ﬁles as you like

according to your umask setting. However, this only affects the

products/ﬁles that you are currently installing. Any ﬁles that are

currently set to have write privileges to the group "other" will have to

be changed manually. This -u ﬂag is only applied for the extraction of

CS3 on the Solaris platform.