Specifications

Patches Issued Since the CS2/MMS2 Release

Software Superseded by CS3/MMS3 Software Release Notice for 5.0rev1

5-74 CS3 and MMS3

board and concentrator level. The user should be able to modify

certain attributes of the concentrator, board, and port as needed.

The problem was the ctUPSApp model was not appearing in the

MicroMMAC's Application View even though a UPS was physically

connected to the com 1 port of a MicroMMAC. The ctUpsID oid had to

be set through mibtools before the model would appear. Until this

application appears, a user cannot set the appropriate "UPS Model" in

the Performance View.

The resolution was to add CtUPSMib as a base model type. If it fails

to get read during the creation process of the ctUPSApp model the

SPECTRUM will try to write to it. This action would then cause the

CtUPSApp to be activated.

The problem is when Cabletron EMME, MicroMMAC and SEHi

devices reboot the security conﬁguration is deleted and must be

manually reconﬁgured on the box. The customer would like the ability

to use ECM to save and restore port locking information on these

devices. These devices use RptrRev4Mib and they do not include the

security attributes available in the RptrRev4SecMib. The

RprtrRev4SecMib cannot simply replace the RptrRev4Mib for these

devices because of ﬁrmware issues.

The resolution was to add the security attributes from the

RprtrRev4SecMib via a new model type: RptrRev4SecFrag. The

attributes created under RptrRev4SecFrag are:

rptrSrcAddrListId

rptrSrcAddrAddressList

rptrSrcAddrSrcTableEntryId

rptrSrcAddrSrcTableEntryPort

rptrSrcAddrSrcTableEntryPortGroup

rptrSrcAddrMgmtSrcAgeInterval

rptrSrcAddrMgmtPortLock

rptrSrcAddrMgmtActiveUsers