Specifications

Patches Issued Since the CS2/MMS2 Release

Software Superseded by CS3/MMS3 Software Release Notice for 5.0rev1

5-72 CS3 and MMS3

The problem is that the CsGib/HubCat5000/CsConfg.GTb table has

incorrect column heights which causes the listbox to create a

horizontal scroll bar outside the viewing area. This causes the

SpectroGRAPH to core dump when viewed if the text exceeds the

speciﬁed length.

The resolution was to change the column heights to ﬁt inside the

viewable area.

The problem was that the Device Chassis View of the 2E253-49 was

not comprehensible. All the ports were squeezed together making all

the information in them useless. The 2E253_29R was using the wrong

iib ﬁle, making it look like a 6000 series management module for the

Device Chassis View.

The resolution was to correct the Iib ﬁle so that the Device Chassis

View is understandable and uncrowded.

The problem was that after installing Spectrum_5.0rev1.MMS1, the

model name could not be edited in the Model Information View for a

HubSyn27xx model type.

The resolution was to change the Model Name ﬁeld in SG-Support/SG-

Support/CsGib/HubSyn27xx/CsStandard.30 from readonly to

readwrite. This allows the model name to be edited in the Model

Information View for a HubSyn27xx model type.

The problem was that a "Device Not Conﬁgured" error message

appears when attempting to get to the DevTop View of a FddiMAC

model of model type's 2E42-27 or 2E42-27R with HSIM-F6's installed.

This problem was found particularly with the following install

conﬁguration: 4.0rev3, MS1, RS3, MS2 and MS3, CS1/MMS1. Also,

no FDDIPort's (A-Type and B-Type) were showing in the DevTop View

of the FddiMAC models. Only Rptr Port models were present.

This problem was two-fold:

There was an attribute, PORTS_STATE that did not exist for any

SS2000 model type that was NOT derived from MicoLANModule

(most 2000 devices). The intelligence tried to read this attribute