Specifications

Patches Issued Since the CS2/MMS2 Release

Software Superseded by CS3/MMS3 Software Release Notice for 5.0rev1

5-58 CS3 and MMS3

The problem was a SpectroGRAPH core dump was occurring when the

cacheZoomedImages from False to True and the defaultZoomLevel

was set to 50%. A core trace was made available. Further, if the

resource "*shadow" in the spectrum ﬁle is set to "false" setting

*cacheZoomedImages to true dumps SpectroGRAPH.

The resolution was to modify SPECTRUM so that SpectroGRAPH will

not core dump whether or not "*shadow" is set to "true" or "false" and

whether or not cacheZoomedImages is set to "true" or "false" and the

defaultZoomLevel was set to 50%.

The problem was after loading ﬁrmware revision 2.21 on a 3Com

LinkSwitch (LS) [Superstack II] 3300 device, a ""Device not

Conﬁgured" message appears in the DevTop View.

The resolution was to modify the algorithm for creating the 3Com

LinkSwitch Chassis model in the DevTop view after ﬁrmware revision

2.21 is loaded.

The problem was there was a SpectroGRAPH core dump when exiting

a BdgCSIFDM DevTop View. An adb core trace as well as a Purify

trace were made available.

The resolution was to correct the array by the traces.

The problem was GRAY models in SPECTRUM were turning GREEN

based on the success of a ping request even though Primary

Management was not available.

The resolution to this was to remove the disassert call from the

are_you_up method. Previous changes assure that GRAY models are

pinged on the poll cycle, this will ensure that the model will not stay

GRAY, but will transition to ORANGE on the next poll cycle.

The problem was the port status for SEHI-24 and SEH-24 model types

was blank on each port model in the Device Chassis View. The port

status should be located in the upper right hand corner of the port

model.