Specifications

9032277-04 Software Superseded by CS3/MMS3

5-55

Patches Issued Since the CS2/MMS2 Release

SPECTRUM_5.0rev1.P98

Obsoleted by SPECTRUM_5.0rev1.P100

SPECTRUM_5.0rev1.P99

Obsoleted by SPECTRUM_5.0rev1.P100

SPECTRUM_5.0rev1.P100

Included in SPECTRUM_5.0rev1.P101

SPECTRUM_5.0rev1.P101

The problem was after modeling a TRMM with a TRMIM-62A, the

Chassis Logical View doesn't appear correctly. In the devtop view, the

TRMIM-62A is labeled "unknown" in the chassis in the center top

window. This occurs with 3.01.01 and 3.02.00 ﬁrmware. The customer

has provided simulations of the device with both versions of ﬁrmware.

The resolution was to fully support the TRMIM-62A management

module in SPECTRUM.

The problem is the customer is seeing that a WA_Link will be RED

and the far side router will be GREY but the serial interface of the

near side router is Admin/Oper on. When they bring up the DevTop of

the far side router, everything turns back to GREEN. They have also

seen the opposite. Everything is GREEN but the serial interface of the

near side router is Admin/Oper off. When they bring up the DevTop of

the far side router, the WA_Link turns RED and the far side router

goes GREY.

If you start out with a Green inside router, green WA_Link, and green

farside router, then change the community string on the farside router

model to something bogus, it goes orange. Its interface IPLS goes to 4

(unreachable). If we then set the nearside interface to Admin down

Oper down, its IPLS goes to 3 (Disabled). The farside router goes grey,

and the link goes solid orange, then solid grey, then solid orange, then

after a long while red.