User`s guide

SFVRA Connection Manager 73
C ONFIGURING U SERS
Telephone
CONNECT TYPE
The type of connection that is to be made when the Remote Access Switch attempts to connect to
the user. This feature dictates what connection type the CyberSWITCH systems are to use to reach
a user. This option only specifies outbound connection types. Available connection types are:
•ISDN
• Dedicated
• Digital Modem
T
ELEPHONE NUMBER(S)
This configuration element is required when the Callable feature is used. The callable capability
allows the SFVRA-CONN to initiate connections to PPP devices located at remote sites. A phone
number must be defined for each remote device that will be dialed. This number includes any
prefix digits, area codes, or extensions required to dial the destination device. It is possible to
specify eight phone numbers for the remote device.
The system dynamically controls the bandwidth in use between the system and other devices. This
is accomplished by establishing and disconnecting up to 8 calls to a single remote site over the
digital network. The system monitors the connections for utilization and will add and remove
connections based on the user configurable parameters described above (base data rate, initial data
rate, and maximum data rate).