User`s guide

SFVRA Connection Manager 55
C ONFIGURING U SERS
Protocols
CONFIGURING THE BRIDGING PROTOCOL
1. On the Functions menu, select Users, or click on the toolbar. The User List dialog appears.
2. Select a user that which you want to configure for the Bridging protocol, or click Add to
configure a new user. The User dialog appears.
3. Select Bridging on the Protocols tab.
4. Enable Bridging by clicking in the box.
5. Determine if the user is Callable.
Note: A telephone number through which a CyberSWITCH can establish a connection must
be configured before enabling the callable function. See Configuring Telephone.
6. Click Update to write the new information for the user to the database, or click Add to create the
newly configured user.
Note: If you are adding a new user to the database, a User Name must be defined on the
Address tab.
7. Click Close.
IP R
EMOTE LAN
The WAN (Remote LAN) IP Network Interface allows remote MAC layer-bridge devices to connect
to an IP subnet. The CyberSWITCH treats all devices connected to the RLAN IP Network Interface
as if they were connected to the same Ethernet segment. The system provides an explicit IP router
presence on this RLAN that is implemented over ISDN. IP Address Resolution requests are
intelligently propagated to remote bridged networks connected on the RLAN IP network interface.
The WAN (Remote LAN) IP Network Interface is used for CPP Bridge and PPP remote devices.
Configuring IP Remote LAN
1. On the Functions menu, select Users, or click on the toolbar. The User List dialog appears.
2. Select a user that which you want to configure for the IP RLAN options, or click Add to
configure a new user. The User dialog appears.
Note: If Bridging has not been configured for this user, see Configuring the Bridging Protocol
for more information.
3. Select Bridging on the Protocols tab.
4. Enter the IP (Sub-) Network Number of the IP RLAN Interface.