User`s guide

USER’S GUIDE
54 SFVRA Connection Manager
ENABLE
Enabling Bridging indicates that the user is a Bridge and the CyberSWITCH connected to it should
route Bridge datagrams to this user based on Bridge network layer information.
C
ALLABLE
Callable indicates that a CyberSWITCH is to initiate connections to this user based on a Bridge
packet. This feature is valid only if bridging is enabled, and the user is properly configured for dial
out.
IP (S
UB-)NETWORK NUMBER
If the CyberSWITCH uses an IP RLAN interface to connect to a remote bridge, you must provide
this information. This address associates the bridge with the IP network to which it connects. Enter
this address using dotted decimal notation. This parameter applies to the network-portion of the
IP address only. Note that if you change the IP address under the IP protocol selection, this
parameter will reflect that change.
IPX N
ETWORK NUMBER
The IPX Network Number specifies the IPX network that is used on the remote LAN for the user.
This hexadecimal number ranges from 1 to 4 bytes in length. None indicates that the remote LAN
does not have an explicit IPX network number and will be associated with the first configured IPX
RLAN interface on a CyberSWITCH.