User`s guide

USER’S GUIDE
44 SFVRA Connection Manager
DYNAMIC ADDRESS ASSIGNMENT
Indicates that this user will be assigned an IP Address by a Remote Access Switch when the user
dials in to the CyberSWITCH. This feature will only work properly if at least one Remote Access
Switch that can reach the user has enabled the IP Pool.
IP I
NPUT FILTER
An IP Input Filter monitors packets that this user sends into SFVRA-CONN’s local subnet. The
filter must be previously defined on the Remote Access Switches. Undefined filters will be ignored.
IP O
UTPUT FILTER
An IP Output Filter monitors packets that this user receives out from the SFVRA-CONN’s local
subnet. The filter must be previously defined on the Remote Access Switches. Undefined filters will
be ignored.
C
ONFIGURING THE IP PROTOCOL
1. On the Functions menu, select Users, or click on the toolbar. The User List dialog appears.
2. Select a user that which you want to configure for the IP protocol, or click Add to configure a
new user. The User dialog appears.
3. Select IP on the Protocols tab.
4. Enable IP by clicking in the box.
5. Determine if the user is Callable.
Note: A telephone number through which a CyberSWITCH can establish a connection must
be configured before enabling the callable function. See Configuring Telephone.
6. Enter the IP Address of this user, or enable Dynamic Address Assignment so that the user will be
assigned an address upon connecting with a CyberSWITCH.
7. Optional: enter an IP Input Filter.
8. Optional: enter an IP Output Filter.
9. Click Update to write the new information for the user to the database, or click Add to create the
newly configured user.
Note: If you are adding a new user to the database, a User Name must be defined on the
Address tab.
10. Click Close.
Note: An IP Network Interface must be defined on all Remote Access Switches that each IP user
can access. Refer to the IP Network Interfaces section in the CyberSWITCH documentation
for further information.