User`s guide

SFVRA Connection Manager 43
C ONFIGURING U SERS
Protocols
IP
When IP is enabled, the CyberSWITCH acts as a router, routing IP datagrams based on IP address
information to the user. The default configuration is IP disabled.
Note: If the bridge and the IP options are enabled, the SFVRA-CONN will instruct the
CyberSWITCH to act as a brouter. A brouter operates as a router for protocols it can route,
and operates as a bridge for protocols it cannot route.
E
NABLE
Enabling IP indicates that the user is an IP Router and that the CyberSWITCH connected to it
should route IP datagrams to the user based on IP network layer information.
C
ALLABLE
Callable indicates that a Remote Access Switch is to initiate connections to this user based on an IP
packet. This feature is available only if IP is enabled, and the user is properly configured for dial
out. This feature cannot be used with Dynamic Address Assignment.
A
DDRESS
The IP address of the remote device. Use 0.0.0.0 to indicate an UnNumbered Interface. This feature
is only available if IP is enabled.
Notes: If you change the IP address under the Bridging protocol selection, this parameter will
reflect that change.
This field can also be used to specify an IP (Sub-)Network Number for bridge devices
connecting to Remote LAN interfaces.