User`s guide

USER’S GUIDE
188 SFVRA Connection Manager
CONFIGURE THE CYBERSWITCH
Configure the CyberSWITCH systems according to the procedures in the appropriate
documentation. The purpose of this section is not to describe the configuration steps of
CyberSWITCH systems, but to point out the areas that are necessary for the users to gain access
under control of the SFVRA-CONN.
CONFIGURING THE CYBERSWITCH TO INTERACT WITH SFVRA-CONN
Using CFGEDIT the following information must be configured for an AppleTalk network to be
successful:
Select Physical Resources from the Main Menu
Select Current Resources
Add ETHERNET-1 resource, slot 3
Select Options from the Main Menu
Select IP
Enable IP routing. Define the Interface type to be LAN. Enter
128.1.1.4 as the IP
Address. Accept the default RIP Receive Control.
Select Security from the Main Menu
Select Security Level
Enable Device Level Security
Select System Options and Information
Enter
APPLETALK_CSX as the System Name
Select Device Level Databases
Select VRA Manager as the Authentication Database location.
Select Off-node Server Information
Select VRA Manager and configure
2000 for the TCP Port number.
CONFIGURING THE CYBERSWITCH TO INTERACT WITH APPLETALK USERS
Select Physical Resources from the Main Menu
Select Current Resources
Add a BRI resource, include slot and port numbers and switch type
Select Current Data Lines
Add a line, include the name, slot and port numbers, type, and datalinks, if
necessary.
Select Options from the Main Menu
Select AppleTalk Routing
Enable AppleTalk Routing. Define a WAN UnNumbered AppleTalk port.
Note: Security options should not be configured on the CyberSWITCH systems, since SFVRA
Connection Manager handles these features.