User`s guide

A PPLE T ALK N ETWORK E XAMPLE
OVERVIEW
This chapter provides an example configuration of an AppleTalk Routing network. Our AppleTalk
network is made up of two LANs, separated by the WAN. The Macs on each side of the WAN need
to exchange packets with the MACs on the other side of the WAN. Both LANs also have a
CyberSWITCH (SITE1 and SITE2). When configured for AppleTalk routing, SITE1 and SITE2 will
provide the access the MACs need.
INITIAL INSTALLATION STEPS
The first step to configuring a network administered by SFVRA Connection Manager is to fill out
the network worksheets located in the CyberSWITCH documentation. Once you complete the
worksheets, you may begin installing SFVRA-CONN. The initial steps are basically the same no
matter how complicated the network. Refer to the System Installation chapter, which describes in
detail each of these steps.
A Network Topology worksheet for this network is included on the following page.