User`s guide

IPX N ETWORK E XAMPLE
OVERVIEW
This sample network uses IPX protocol to allow remote devices and their servers to communicate.
It illustrates a master network (“Enterprise LAN”) which supports the following:
• a Virtual Ethernet WAN network to communicate with remote bridges (using a Remote LAN
interface)
• a traditional WAN network to communicate with a remote IPX router (using a traditional
WAN interface).
In order for this internetwork to function properly, you must enable bridging and enable IPX on
the master network, as well as configure a combination of interfaces and associated users.
System details appear in the worksheets, followed by a description of this sample’s unique
configuration.
INITIAL INSTALLATION STEPS
The first step to configuring a network administered by SFVRA Connection Manager is to fill out
the network worksheets located in the CyberSWITCH documentation. Once you complete the
worksheets, you may begin installing . The initial steps are basically the same no matter how
complicated the network. Refer to the System Installation chapter, which describes in detail each of
these steps.
A Network Topology worksheet for this network is included on the following page.