User`s guide

SFVRA Connection Manager 163
IP N ETWORK E XAMPLE
Configure User Records
8. Assign the user to a group.
In order for the user “Monterey” to be allowed to connect with the CyberSWITCH “IP_CSX,”
the user must be in the same group. Select Groupings on the Access tab. Select
IP in the User is
not a member of box and click Add.
9. Click Update and then click Close.
10. Click Close on the User List dialog.
Next enter the user information for Carmel. This user is also a remote bridge that uses the IP
protocol, and is configured using the same authentication as user Monterey, except we will
configure dharry as the password for user Carmel. Enter 22222222222 for the bridge Ethernet
address. Carmel should be added to the IP group.
CONFIGURING AN IP WAN USER WITH A PPP DEVICE
This sample network uses IP routing to connect two of our products, both using PPP. In this case,
we will use an UnNumbered interface.
Note: This example only provides screen shots that are distinctly different from those in the
previous configuration section. If necessary, refer to the example screens in Configuring IP
WAN Users for more detail.
1. On the Functions menu, select Users, or click on the toolbar. The User List dialog appears.
2. To add remote users, click Add. The User dialog appears.
3. Define the User Name.
On the Address tab, enter
SITE2 for the User Name. Only the User Name is required and it must
be unique. Other fields are informational for use by the Network Administrator or Help Desk.
4. Enable the IP Protocol.
In order for the Remote Access Switches to be able to communicate with each user, the protocol
used by the user needs to be identified. Select IP on the Protocols tab and enable IP. Enter the IP
Address
0.0.0.0 .
5. Click Add.
Certain user features require the user to be configured in the database before the feature itself
can be configured. These feature include: configuring static routes, assigning a user to a group,
and configuring telephone numbers and Calling Line ID’s. The next parameter that we will
configure for user “SITE2” is a static route, therefore we need to add the user to the database
first.