User`s guide

SFVRA Connection Manager 161
IP N ETWORK E XAMPLE
Configure User Records
8. Assign the user to a group.
In order for the user “Fred Bear” to be allowed to connect with the CyberSWITCH “IP_CSX,”
the user must be in the same group. Select Groupings on the Access tab. Select
IP in the User is
not a member of box and click Add. The Groupings tab should appear as shown below:
9. Click Update and then click Close.
10. Click Close on the User List dialog.
CONFIGURING IP WAN USERS WITH REMOTE BRIDGE DEVICES
This sample network has two remote satellite offices in Monterey and Carmel, California that need
to be in daily electronic communication with their Corporate Office in San Francisco. Each satellite
office has an IP Host that communicates through a Remote Bridge. This example uses a WAN
(Remote LAN) Interface to allow the two remote bridge devices to connect to an IP subnet. The
CyberSWITCH treats these devices connected to the RLAN network interface as if they were
connected to the same Ethernet segment.
Note: This example only provides screen shots that are distinctly different from those in the
previous configuration section. If necessary, refer to the example screens in Configuring IP
WAN Users for more detail.
1. On the Functions menu, select Users, or click on the toolbar. The User List dialog appears.
2. To add remote users, click Add. The User dialog appears.