User`s guide

SFVRA Connection Manager 151
B RIDGING N ETWORK E XAMPLE
Verify Configurations
9. Configure Calling Line ID’s.
Since we enabled Check CLID security, we need to configure a Calling Line ID to check. Select
the Telephone tab. Under Calling Line ID(s), click Add, enter
13135551212 , and click OK. Click
Add again, enter
13135552121 , and click OK. The Telephone tab should appear as shown
below:
10. Click Update and then click Close.
11. Click Close on the User List dialog.
Next enter the user information for Pat Smith. This user is also a CPP bridge, and is configured
using the same authentication as user Mike Mann, except we will configure no password for user
Pat Smith. Enter 00345678900 for the bridge Ethernet address, 13135556789 for the first calling line
ID, and 13135559876 for the second calling line ID. Pat Smith should be added to the
REMOTE_BRIDGE group.
VERIFY CONFIGURATIONS
Steps on how to verify the installation are detailed in the System Verification chapter. Refer to the
System Verification chapters of your CyberSWITCH documentation for more specific details on
verifying the CyberSWITCH features. This section gives an outline of which steps should be
executed.
On the SFVRA-CONN Client:
Check Group assignments
On each system:
Verify resources are operational
Verify WAN Lines Available