User`s guide

SFVRA Connection Manager 145

RIDGING

ETWORK

XAMPLE

Configure the CyberSWITCH - User Grouping

CONFIGURE THE CYBERSWITCH - USER GROUPING

Note: The SFVRA Connection Manager software should have already been installed, and the

Client interface should be activated before proceeding with the following steps.

We will begin the network configuration by defining a CyberSWITCH - User Group. These groups

can be used to determine which Remote Access Switches users are allowed to call. In this example,

we will configure a group based on the user’s protocol. Refer to Configuring CyberSWITCH - User

Groups for more information.

Note: CyberSWITCH - User Groupings can be used for all types of users, from all areas of your

network. In this example, we are grouping users by protocol for ease of understanding the

feature only.

1. On the Tables menu, select CyberSWITCH - User Grouping. The Table Maintenance dialog

appears.

2. Click Add.

3. Enter the name

REMOTE_BRIDGE

, and click OK.

4. Click Close.

CONFIGURE THE CYBERSWITCH ON SFVRA-CONN

Note: The Client interface should be activated before proceeding with the following steps.

In our example, we only need to supply general properties of the CyberSWITCH in order for

SFVRA-CONN to be able to communicate with it. SFVRA-CONN requires a unique name for each

CyberSWITCH. It also requires the IP address of the LAN port through which a TCP connection is

established to send and receive information. We will also assign the CyberSWITCH to the group

that we previously defined. Lastly, in order for the SFVRA-CONN to allow the CyberSWITCH to

take incoming calls from users, we must define the number of channels it has available. The

Network Topology diagram states that this CyberSWITCH has a BRI resource. For purpose of this

example, we will assume that the resource is a BRI-4 adapter. Refer to Configuring Remote Access

Switches for more information.

1. On the Functions menu, select CyberSWITCH, or click on the toolbar. The CyberSWITCH

List dialog appears.

2. Click Add. The Remote Access Switches dialog appears.