User`s guide
USER’S GUIDE
144 SFVRA Connection Manager
CONFIGURE THE CYBERSWITCH
Configure the CyberSWITCH systems according to the procedures in the appropriate
documentation. The purpose of this section is not to describe the configuration steps of
CyberSWITCH systems, but to point out the areas that are necessary for the users to gain access
under control of the SFVRA-CONN.
CONFIGURING THE CYBERSWITCH TO INTERACT WITH SFVRA-CONN
Using CFGEDIT the following information must be configured for a bridging network to be
successful:
Select Physical Resources from the Main Menu
Select Current Resources
Add ETHERNET-1 resource, slot 3
Select Options from the Main Menu
Select IP Routing
Enable IP routing. Define the Interface type to be LAN. Enter
128.1.1.1
as the IP
Address. Accept the default RIP Receive Control.
Select Security from the Main Menu
Select Security Level
Enable Device Level Security
Select System Options and Information
Enter
BRIDGE_CSX
as the System Name
Select Device Level Databases
Select VRA Manager as the Authentication Database location.
Select Off-node Server Information
Select VRA Manager and configure
2000
for the TCP Port number.
CONFIGURING THE CYBERSWITCH TO INTERACT WITH BRIDGE USERS
Select Physical Resources from the Main Menu
Select Current Resources
Add a BRI resource, include slot and port numbers and switch type
Select Current Data Lines
Add a line, include the name, slot and port numbers, type, and datalinks, if
necessary.
Select Options from the Main Menu
Select MAC Layer Bridging
Enable Bridging. All other features are optional and are not directly supported by
SFVRA-CONN. This means that they can still be configured, with the noted sug-
gestions, but that the configurations are managed on the CyberSWITCH systems
only, and these features should be identical on all CyberSWITCH systems within
the same group. Bridge Dial Out and Known Connect List are the exceptions. Since
SFVRA-CONN performs the functions of these features, they should not be config-
ured on the individual CyberSWITCH systems.
Note: Security options should not be configured on the CyberSWITCH systems, since SFVRA
Connection Manager handles these features.