Specifications

CyberSWITCH 200 Series and 400 Events and Alarms
Event and Alarm Messages CyberSWITCH Devices (200 Series and 400)
4-10 Management Module Guide
CsEvFormat/Event000d0131
{d “%w- %d %m-, %Y - %T”} - Collision
threshold exceeded. The number of
collisions per total packets within the
time base of {I 3} seconds has been
exceeded on repeater network {I 5} of
{m} ({t}). (event [{e}])
CsPCause/Prob000d0131
A user defined threshold has been
exceeded on this channel. This threshold
could indicate that a malfunctioning
device is present on this channel, or that a
cable fault exists. Collisions are usually
caused by many nodes contending for the
network. As traffic rates increase, the
collision rate usually follows. Therefore, if
this channel has a high bandwidth
utilization, a high collision rate is not
unlikely. Use module and port level
thresholds to further troubleshoot to a
device level.
CsEvFormat/Event000d0132
{d “%w- %d %m-, %Y - %T”} - Network
port security is {T LockStatus 1} on
repeater network {I 3} of {m} ({t}).
(event [{e}])
CsPCause/Prob000d0132
The network administrator has changed
the status of port locking for this repeater
channel. The security feature locks all
ports on this repeater channel so that only
a valid user already in the source address
table can access the network.
CsEvFormat/Event000d0133
{d “%w- %d %m-, %Y - %T”} -
Broadcast threshold exceeded {I 1}
total packets in {I 3} seconds on
repeater network {I 5} of {m} ({t}).
(event [{e}])
CsPCause/Prob000d0133
REPEATER BROADCAST THRESHOLD
EXCEEDED
This trap will be generated when the
broadcast (packets per time interval) has
been exceeded for the repeater.
CsEvFormat/Event000d0135
{d “%w- %d %m-, %Y - %T”} - Port
Security Status is {T LockStatus 3} for
port #{I 2}, located in port group #{I 1}
of {m} ({t}). (event [{e}])
CsPCause/Prob000d0135
PORT SECURITY STATUS
This alarm is generated when a change in
the lock status for a particular port occurs.
CsEvFormat/Event000d0136
{d “%w- %d %m-, %Y - %T”} - Device
configuration change reported by {m}
({t}). A module has been inserted into
slot {I 1}. (event [{e}])
CsPCause/Prob000d0136
A module has been inserted into this hub.
Table 4-1. CyberSWITCH 200 Series and 400 Events and Alarms (Continued)
Message in the Event Log
Alarm Manager Probable Cause
Message