Installation guide

Chapter 2: INSTALLING THE CSMIM-T1
2-10 CSMIM-T1 Hardware Installation Guide
At the monitor prompt on the console, type config and press the
Return key. The following appears on the screen:
REVISION/CONFIGURATION INFORMATION
ROM Software Rev: 0914
Board ID: 42 Board Type: CSMIM-T1
CPU Type: 486SXLC2 Ethernet Address: 00-80-2D-00-18-B6
Memory size: 4 Meg EEPROM size: 65504
Flash size: N/A Flash ID: N/A
T1 Unit Identification: XYLOGICS T1-ENGINE 085234 Rev. A 07/19/95 6343
T1 Network Jumper: Cross Connect Mode
DS0: B8ZS Coding ESF Framing AT&T FDL Format
DSX: B8ZS Coding ESF Framing Line Distance=535 to 635 Feet
Port # 123456..... 11 12
T1 Slot Map NNNNNN..... N N
Mod ID 288X 288X 288X 288X 288X 288X ..... 288X 288X
Mod Status OK OK OK OK OK OK ..... OK OK
Port # 13 14 15 16 17 18 ..... 23 24
T1 Slot Map NNNNNN..... N N
Mod ID 288X 288X 288X 288X 288X 288X ..... 288X 288X
Mod Status OK OK OK OK OK OK ..... OK OK
To record the CSMIM-T1’s Ethernet address for future reference: at the
monitor prompt, type addr -d and press the Return key. The display
looks like this:
monitor:: addr -d
Ethernet address (hex): 00-80-2D-00-18-B6
Internet address: <uninitialized>
Subnet mask: 255.0.0.0
Broadcast address: 0.0.0.0
Preferred load host address: <any host>
Preferred dump address: 0.0.0.0
Load/Dump Gateway address: <uninitialized>
Type of IP packet encapsulation: <ethernet>
Load broadcast: Y
NOTE
You are prompted for the gateway address only if the Internet
address differs from the preferred Load Host address based on
the Subnet Mask. If these addresses are the same, the
CSMIM-T1 assumes there is no gateway.