Installation guide

Chapter 2: INSTALLING THE CSMIM-T1
2-2 CSMIM-T1 Hardware Installation Guide
2.2 LOCATING THE ETHERNET JUMPERS
The CSMIM-T1 has a single jumper block that contains two Ethernet
jumpers and one Subnet jumper. Figure 2-1 shows the locations and
jumper numbers for the Ethernet and Subnet jumpers. Please note that the
jumpers are located on the Main Processor Board, not the modem board.
Figure 2-1 CSMIM-T1 Jumper Settings
J12
Ethernet Jumper J12
Jumper Settings for
operating on Ethernet A
Jumper Settings for
operating on Ethernet B
(factory setting)
Jumper Settings for
operating on Ethernet C
ETHERNET JUMPER SETTINGS
SUBNET JUMPER SETTINGS
Full Segment
(Normal Setting)
Sub-Net
(Channels B and C)
FUSE
1 2 3
A
B
C
1 2 3
A
B
C
1 2 3
A
B
C
1 2 3
A
B
C
1 2 3
A
B
C
1 2 3
A
B
C