Specifications

What Is in This Chapter
Port Configurations Table
Configuration Views SynOptics 28000 Series Switches
3-6 Management Module Guide
the value of this parameter may be automatically set whenever the expansion
port is connected to another switch.
Media Type
Displays the media type for the port. See Table 3-2 for a list and description of
Media Types.
Port Speed
Displays the speed of the port. See Table 3-4 for a list of the possible speeds.
The port media type (expansion or regular) and port link type (trunk or
feeder) determine the valid values, and whether you can change the speed.
You cannot change the speed for trunk ports.
For expansion ports, the “s100” and “s200” can be set. However, the value of
this parameter may be automatically set whenever the expansion port is
connected to another switch.
Link Type
Displays the type of link for the port. See Table 3-3 for a list and descriptions
of the possible types.
Configuration Changes
Displays the total number of port configuration changes to this switch
including port partition/unpartition, port speed change, port reset and port
half/full duplex change, since warm/cold restart.
Last Change
Displays the value of sysUpTime when the last port configuration change to
the switch was detected. If none have been detected of the domain since warm/
cold restart, then the value is zero.
Port Reset
Action object to reset a port. Possible values are “reset” and “resetOK.”