- Cabletron Bridge/Router User's Guide

SYNC PORT LEDS

BRIM-WT1 USER’S GUIDE Page 23

4.3 SYNC PORT LEDS

The following LEDs indicate the status of the SYNC port.

DSR (Data Set Ready)

• On - Indicates that the DCE is ready to operate, or that the Force

DSR True ﬁeld (refer to the WAN Physical Conﬁguration screen) is

set to YES (On).

• Off - A valid DSR is not being received from the DCE. Check the

cabling or check if the DCE is powered on.

CTS (Clear to Send)

• On - Indicates that the DCE is ready to receive data from the

BRIM-WT1, or that the Force CTS True ﬁeld (refer to the WAN

Physical Conﬁguration screen) is set to YES (On).

• Off - A valid CTS is not being received from the DCE. Check the

cabling or check if the DCE is powered on.

LNK (Link)

• On - Indicates that the BRIM-WT1 is receiving a valid clock from

the DCE.

• Off - Indicates that the BRIM-WT1 is not receiving a valid clock

from the DCE. Check the cabling, check that the DCE is powered

on, or check that the clock source is set properly in the DCE.

TST (Test)

• On - Indicates that the SYNC port is in test mode.

• Off - Indicates that the SYNC port is in non-test mode.