Specifications

9031586 E3 Event and Alarm Messages
4-9
Events and Alarms
CsEvFormat/Event000d0129
{d "%w- %d %m-, %Y - %T"} Traffic
threshold, {I 1} packets per {I 3} seconds,
exceeded on the repeater network {I 5} of
{m} ({t}). (event [{e}])
CsPCause/Prob000d0129
The device(s) attached to this channel
may have an application level problem.
The attached devices may be operating
properly, but the application requires a
large amount of network bandwidth. If
the application requires a large amount of
bandwidth, a bridge or router may be used
to logically separate various network
segments. This trap indicates that module
or port level thresholds on this repeater
channel are needed to pinpoint high
bandwidth users.
CsEvFormat/Event000d0130
{d "%w- %d %m-, %Y - %T"} Error
threshold exceeded. An error threshold, of
{I 1}% total packets in {I 5} seconds,
exceeded on repeater network {I 7} of {m}
({t}). (event [{e}])
CsPCause/Prob000d0130
A user defined threshold has been
exceeded on this channel. This threshold
could indicate that a malfunctioning
device is present on this channel or that a
cable fault exists. A module or port level
threshold should be set to further
troubleshoot to the offending node.
CsEvFormat/Event000d0131
{d "%w- %d %m-, %Y - %T"} Collision
threshold exceeded. The number of
collisins per total packets within the time
base of {I 3} seconds has been exceeded on
repeater network {I 5} of {m} ({t}). (event
[{e}])
CsPCause/Prob000d0131
A user defined threshold has been
exceeded on this channel. This threshold
could indicate that a malfunctioning
device is present on this channel, or that a
cable fault exists. Collisions are usually
caused by many nodes contending for the
network. As traffic rates increase, the
collision rate usually follows. Therefore, if
this channel has a high bandwidth
utilization, a high collision rate is not
unlikely. Use module and port level
thresholds to further troubleshoot to a
device level.
CsEvFormat/Event000d0132
{d "%w- %d %m-, %Y - %T"} Network port
security is {T LockStatus 1} on repeater
network {I 3} of {m} ({t}). (event [{e}])
CsPCause/Prob000d0132
The network administrator has changed
the status of port locking for this repeater
channel. The security feature locks all
ports on this repeater channel so that only
a valid user already in the source address
table can access the network.
Table 4-1. Device Events and Alarms