Specifications

2-18 SmartSwitch ATM Switch Reference Manual
ATMRoute Console Commands
Descriptions
Examples
switch_prompt # show atmroute
Num(ALL) :
Num Port Number ATM Address Type Proto
================================================================================
1 CPU 39:00:00:00:00:00:00:00:00:00:a3:87:0b:00:00:1d:a3:87:0b I MGMT
2 CPU 39:00:00:00:00:00:00:00:00:00:a3:87:0b:00:00:64:01:01:16 I MGMT
3 -- 39:00:00:00:00:00:00:00:00:00:a3:87:0b:00:20:d4:28:c1:ff I MGMT
4 CPU 47:00:79:00:00:00:00:00:00:00:00:00:00:00:a0:3e:00:00:01 I MGMT
[Metrics Tag] Index into the listing of traffic parameter values that apply for connectivity between the
switch and the reachable address prefix.
[Ptse Id] For reachable addresses learned through PNNI, this parameter contains the value of the
PTSE identifier for the PTSE that is originated by the originating node and contains the
information group(s) describing the reachable address. For reachable addresses learned
by means other than PNNI, this parameter is set to zero.
[Advertising] Whether or not the local switch advertises the local address into the PNNI domain.
Possible values are: Yes and No.
[Oper Status] Whether or not the reachable address prefix is operationally valid and whether it is
advertised by this node. Possible values are: Advertised, Active, and Inactive.
Operator Parameters/Permissions Description
add atmroute
[PortNumber] <portnumber>
[ATMAddr] <atmaddress>
[PrefixLength] <prefixlength>
[AddressIndex] <addressindex>
[Type] <type>
[Scope] <scope>
[MetricsTag] <metricstag>
Administrator
Adds a route to a reachable address from the switch.
delete
atmroute
[PortNumber] <portnumber>
[ATMAddr] <atmaddress>
[PrefixLength] <prefixlength>
[AddressIndex] <index>
Administrator
Deletes a route to a reachable address from the switch.
show atmroute
All Displays the configured routes from the switch.
Output Parameter Description