Specifications

2-16 SmartSwitch ATM Switch Reference Manual
ATMRoute Console Commands
ATMRoute
Use ATMRoute to manage routes to reachable addresses from the switch.
Note The following applies to SmartSwitch 6500 only: You can hot-swap TSMs.
Hot-swapping is replacing a module when the chassis is powered up. If you
replace a TSM with another TSM of the same type (same I/O ports), existing
configuration of port parameters is not affected. This includes parameters set
using any of the following attributes: ATMRoute, CACServiceClassBw,
IlmiConfig, NetPrefix, Port, PortConfig, PVC, PVP, ServiceRegistry, SigTimer,
SigStatistics, SSCOPConfig, and SSCOPStatistics. If you replace a TSM with
another TSM of a different type, existing configuration of port parameters is
deleted. The deletion occurs when the new module is plugged into the chassis
backplane.
Operators
add, delete, show
Parameters
Input Parameter Description Value/Field Size Default
[Num] Index number of the route as assigned
by the console. Use the
show
atmroute all
command to get a list of
index numbers.
Positive integer All
[PortNumber] Port number on the switch. You can
specify a physical or virtual port.
A1 to B4 (physical-2500 family),
A1.n to B4.n (virtual-2500 family),
1A1 to 8B4 (physical-6500),
1A1.n to 8B4.n (virtual-6500),
or All
All
[AtmAddr] Address prefix of the ATM end
system.
No default
[PrefixLength] Length in bits to apply to the address
prefix.
No default
[AddressIndex] Index into the set of listings of
connectivity to the address prefix.
0
[Type] Type of reachability from the switch to
the address prefix.
Exterior, Internal, Reject Internal