Specifications

3-6 SmartSwitch ATM Switch Reference Manual
ponf Command Boot Load Commands
ponf Command
Use ponf to set whether POST diagnostics are run by default when the switch is started.
Examples
=>ponf p
Modifying Control/Stat field to execute POST, please wait...
New postOnOff value programmed successfully into Control/Stat field.
=>
Note ponf does not affect the behavior of the go command.
scsm Command
Use scsm to tell the switch to transfer CSM mastership to the slave CSM.
Examples
=>scsm
Transferring mastership to slave CSM...
=>
Parameter Explanation
s
POST is off. Switch goes directly to start-up.
p
POST is on. Switch runs POST before going to switch
operating software.
none Same as
s; POST is off.