Specifications

SmartSwitch ATM Switch Reference Manual 2-9
Console Commands AtmFilter
AtmFilter
Use AtmFilter to manage ATM filters on the switch.
Operators
add, delete, modify, show
Parameters
In the Output Parameter table below, (
</d>
) indicates parameters that are available only through the show atmfilter
/d
(detailed) command.
Input Parameter Description Value/Field Size Default
[AtmFilterName] Name of the filter. 15-characters
maximum
FILTERXXX, where XXX
is the index.
[AtmFilterType] Type of the filter. Admit, Deny
[SrcAtmAddress] Source (calling party) address (for
which this filter should be applied).
20-bytes maximum
[SrcAtmAddressMask] Mask of the source ATM address. 20-bytes maximum Default mask is created
from the SrcAtmAddress.
[DstAtmAddress] Destination (called party) address
(for which this filter should be
applied).
20 bytes maximum
[DstAtmAddressMask] Mask of the destination ATM
address.
20-bytes maximum Default mask is created
from the DstAtmAddress.
Output Parameter Description
[FilterName] Name of the ATM filter.
[FilterType] Type of the ATM filter. Possible values are: Admit or Deny.
[TotalAdmits] Number of calls that were acted on by this filter that have passed through.
[TotalDenies] Number of calls that were acted on by this filter that have not passed through.
[ReferenceCount] Number of filter sets that are using this filter.